Filter
Top Products
13
Gasoline containing more than 10% ethanol by volume may cause starting and/or performance
problems. Gasoline containing ethanol may be marketed under the name Gasohol.
Methanol (methyl or wood alcohol)
Gasoline containing methanol must contain co solvents and corrosion inhibitors to protect the fuel
system. Gasoline containing more than 5% methanol by volume may cause starting and/or
performance problems and may damage metal, rubber and plastic parts of your fuel system.
MTBE (methyl tertiary butyl ether)
Your may use gasoline containing up to 15% MTBE by volume. Before using an oxygenated fuel, try to
confirm the fuel’s contents. Some states require this information to be posted on the pump. If you
notice any undesirable operating symptoms, switch to a conventional unleaded gasoline.
Fuel system damage or performance problems resulting from the use of an oxygenated fuel are not
the responsibility of factory and are not covered under warranty.
NOTICE
Oxygenated fuels can damage paint and plastic. Be careful not to spill fuel when filling your
fuel tank. Damage caused by spilled fuel is not covered under warranty.
STARTING
Recoil Start
1. Make sure to disconnect all electrical loads from panel receptacles. The generator may be hard
to start if a load is connected.
2. Turn the fuel valve to the ON position.
3. The automatic choke will be closed if the engine is cold. If you want to operate the choke
manually, move the choke rod out of the CLOSED position.
4. Turn the engine switch to the ON position.
5. Pull the starter grip lightly until resistance is felt, then pull briskly.
NOTICE
Do not allow the starter grip to snap back against the engine. Return it gently to prevent
damage to the starter or housing.
6. If you have manually closed the choke, move it to the OPEN position as the engine warms up.
Electric Start
1. Make sure to disconnect all electrical loads from panel receptacles. The generator may be hard
to start if a load is connected.
2. Turn the fuel valve to the ON position.
3. The automatic choke will be closed if the engine is cold. If you want to operate the choke
manually, move the choke rod out of the CLOSED position.
4. Turn the engine switch to the START position.
5. Return the key to the ON position once the engine has started. Do not use the starter
for more than 5 seconds at a time. If the engine fails to start, release the switch and wait 10
seconds before operating the starter again.
6. If you have manually closed the choke, move it to the OPEN position as the engine warms up.