Filter
Top Products
11
Disconnecting the battery cables:
1. Stop the engine.
2. Disconnect the negative (-) battery cable from the generator negative (-) terminal.
3. Disconnect the other end of the negative (-) battery cable from the battery negative (-) terminal.
4. Disconnect the positive (+) battery cable from the generator positive (+) terminal.
5. Disconnect the other end of the positive (+) battery cable to the battery positive (+) terminal.
6. Connect the vehicle ground cable to the battery negative (-) terminal.
7. Reconnect the vehicle grounded battery cable.
PRE-OPERATION CHECK
Engine oil
NOTICE
Engine oil is a major factor affecting engine performance and service life. Non-detergent and
2-stroke engine oils will damage the engine and should not be used.
Check the oil level BEFORE EACH USE with the generator on a level surface with the engine stopped.
Use 4-stroke oil, or equivalent high detergent, premium quality motor oil certified to meet or exceed U.S.
automobile manufacturer’s requirements for Service Classification SG, SF/CC, and CD. Motor oils
classified SG, SF/CC; CD will show this designation on the container. (1) SG.SF/CC.CD SINGLE
VISCOSITY (2) SG.SF/CC.CD MULTI VISCOSITY. SAE 10W-30 is recommended for general,
all-temperature use. Other viscosities shown in the chart may be used when the average temperature
in your area is within the indicated range.
1. Remove the oil filler cap and wipe the dipstick clean.
2. Check the oil level by inserting the dipstick into the filler neck without screwing it in.
3. If the level is low, fill to the top of the oil filler neck with the recommended oil.