Filter
Top Products
17
ENGLAND
I
I2
I3
H3
I1
STARTING UP
Before starting up check the oil and petrol levels.
Do not smoke during the oil and petrol refuelling and checking operations.
Top up with petrol or oil if necessary (as described in detail in the previous
chapter).
Starting up (engine start) must be carried out as described in detail under the heading
“initial starting up”.
Never change gear while driving, the mower must always be at a standstill.
Never mow the grass with reverse gear engaged.
Movement without power.
Only possible with the engine off.
Pushing the mower may be necessary to move it to the storage area.
Should it be necessary to manually move the mower the gear lever must be in the
neutral poistion 'X'.
Warning! For all manual shift operations the engine must be off and the ignition key
removed.
1. Position the gear level (11 pic I) to N (neutral). The mover can be
moved and pushed without any problem.
1. Position the hydrostatic gear block level (16 pic H3) on the discharge
plate to neutral X. At the end of the manual push operation, reposition
lever 16 to drive engagement pos. Y.
DRIVING INSTRUCTIONS (starts at page 88)
Ensure that there are no persons or animals within the operating vicinity of the
machine.
Select the required speed and drive carefully. Transportation of other persons
is strictly forbidden.
Transmission occurs on the rear wheels by means of the hydrostatic gear, braking is
by pressing the pedal (9) on the right of the steering wheel column.
DRIVING (starts at page 88)
1. Press the brake pedal (9) which acts as a clutch, activate the
lever (11 pic I) according to chosen gear, then slowly release
pedal (9) until it starts up.To engage reverse gear, stop, and engage the reverse
and engage the gear (11 pic I) into reverse (R) by pressing the brake pedal (9),
then slowly releasing the brake pedal (9) again.
2. Advance speed may also be varied by manually operating the gas throttle
lever (6 pic H1).
DRIVING
1. Release the lever (10) and press the brake pedal (15) slowly fully down.
2. Advance speed may also be varied by manually operating the gas throttle lever (6 pic
H1).
BRAKING
Remove the right foot from the drive pedal (15 pic I1). Press the brake
pedal (9). To activate the parking brake, pull the lever (10 pic I2) upwards.
Pressing by the brake, the drive pedal will automatically position itself on neutral.
BRAKING (starts at page 88)
Press the brake pedal (9 pic I1).
To lock the brake pedal (9) use the lever (10).
DRIVING NOTICE
If possible, avoid driving at full throttle.
ENGAGING THE MOWER MECHANISM (starts at page 88)
1. Engage the brake (9)
2. Set the lever (12) on START position
The mower mechanism is now engaged and the blade is rotating.
3. It is possible to begin cutting in forward gear after having released the brake pedal.
If the user stands up from the seat during the mowing, the engine switches off.
SWITCHING OFF THE MOWER GEAR
Set the clutch blade lever (12) into STOP position.
The blade stops turning in about 5 seconds.
SAFETY RULES
1)All persons operating the ride-on lawnmower must be familiar with the operating
instructions.
lVery important regulation: anybody under the age of 16 or under the effects of alcohol
or medicines cannot operate the machine.
2)Exhaust fumes from petrol engines: these fumes contain harmful carbon monoxide,
never operate the engine in closed environments.
3)When operating on the ride-on lawnmower make sure that no other persons, especially
children or pets, are in the vicinity of the ride-on lawnmower.
4)Please ensure that foreign matters (strips, twigs, iron wire, etc.) are removed from the
lawn. Splinters can be hurled outwards or the blades can get damaged.
5)No smoking in the vicinity of the mower during operation.
6)Only mow during daylight or under good lighting conditions.
7)Only Mow up or downwards a slope NEVER at an angle to the slope. Special care is
needed when changing direction on slopes.
8)When driving to the area to be mowed, the ride-on lawnmower mechanism must not
be switched on.
9)Never use machine in the event of damage to the bodywork or without protective
equipment (i.e. grass collector bag, etc).
10)The correct position of the engine block has been specifically designed and set at the
factory and must not be altered
11)Start by pressing the drive pedal with the greatest care, following the manufacturer’s
instructions. Pay attention to feet positioning at a sufficient distance from the cutting
blade.
12)Do not tilt the engine when departing and starting up.
13)This ride-on lawnmower has a safety device which switches off the engine every time
that the operator leaves his seat.
14)Keep your hands or feet away from the rotating blades. Stay away from the discharge
opening whilst the blade are rotating.
15)Do not manually move or lift the machine with engine running.
16)In the event of engine blockage, clogging of the discharge channel and in all
maintenance operations on the cutter mechanism and in cases of temporary removal
of the safety protections the engine must be switched off and the cutter mechanism
disengaged.
Important: remove the ignition key.
17)The engine must also be switched off:
lwhen you leave the machine or during its transportation
lbefore refuelling
lduring the grass collection bag emptying operations.
18)Take the greatest care during the cutter regulation operations. Risk of injury!! Keep
fingers away from the area between cutter and bodywork. Wear gloves.
19)Only empty the petrol tank in the open.
20)Before storing in a closed room, let the engine cool down.
21)In order to avoid risk of fire, the engine and exhaust must be kept free of grass, leaves
and leaking grease.
22)The grass collection bag must regularly be checked for signs of damage
23)Do not mow in reverse.
Maintenance and storage
1)Make sure that all nuts, bolts, and screws are kept well tightened to keep the mower in
a safe operating condition.
2)Never leave the machine with fuel in the tank within an enclosed area where the fuel
vapours could reach naked flames or sparks.
3)Allow the engine to cool before storing in any enclosure.
4)Keep the engine, silencer, battery compartment and petrol tank free from grass, leaves
and excess lubricant, in order to reduce the danger of fire.
5)Frequently check the grass bag for wear or deterioration
6)For safety reasons, be sure to replace worn-out or damaged parts in due time.
7)If the fuel tank has to be drained, it is essential that this be done outdoor.
8)Assemble the blades following the corresponding instructions and use only blades
bearing the maker's name or the trademark of the manufacturer or supplier and marked
with the reference number.
9)To protect hands during disassembly or assembly of the blades, it is absolutely essential
to wear suitable protective gloves.
OPERATING THE MOWER MECHANISM
The mower mechanism can only be switched on when the machine is at a standstill
(parking brake engaged), with engine running, and throttle on (full) and with
operator seated on the mower.
MOVING WITHOUT GEAR PEDAL ENGAGED (starts at page 88)