Filter
Top Products
8
• It is not permitted to fill fuel above the shoulder
level of fuel tank.
• Slide switch to START/RUN position as shown.
• Push purge bulb 3 or 4 times (or until constant
flow of fuel is visible in fuel return line.)
• Move choke lever to COLD START (Close)
position.
• Press the decompression device.
• Pull starter handle until the engine fires. Now,
move choke lever to RUN (open) position, and
if necessary, restart the engine again and allow
to warm up for a few minutes before using.
• After idling, gradually open throttle and cutter
blade will start to operate as the engine attains
clutch engagement speed of 3,500 r/min
approximately.
STARTING COLD ENGINE
WARNING DANGER
••
••
•WHEN ENGINE IS STARTED, CONFIRM IF
THERE IS NOT ANY ABNORMAL
VIBRATION OR SOUND. IF THERE IS
ABNORMAL VIBRATION OR SOUND, ASK
YOUR DEALER TO REPAIR.
••
••
•AFTER REFUELING TIGHTEN FUEL CAP
FIRMLY AND CHECK FOR LEAKAGE. IN
CASE OF FUEL LEAKAGE REPAIR BEFORE
STARTING OPERATION SINCE THERE IS A
DANGER OF FIRE.
Throttle trigger
Ignition switch
Throttle control lockout
Sholder level
Fuel tank
Purge bulb
Fuel return line
COLD START (Close)
RUN (Open)
Starter handle
Choke lever
NOTE
Starter handle: Use short pulls - only 1/2 - 2/3 of
starter rope for starting. Do not let starter rope
snap back in .
Always hold the unit firmly.