Filter
Top Products
5
ASSEMBLING
DRIVE SHAFT
• Stand engine upright on a level floor.
• Loosen bolts at drive shaft end of the engine.
• Fit drive shaft assembly ensuring that the drive
shaft is correctly engaged.
• Tighten bolts to fasten drive shaft assembly.
WARNING DANGER
NEVER START ENGINE WITHOUT
DRIVESHAFT ASSEMBLY INSTALLED.
THIS COULD RESULT IN SERIOUS INJURY.
Remove bolt retainer tube from end of handle
assembling bolt (8 mm).
Handle assembling bolt (8 mm)
Install handle assembling bracket (upper) in handle
assembling bracket (lower) and fix handle by tightening
handle assembling bolt (8 mm) lightly.
Handle assembling bracket (upper)
Insert right hand grip assembly into right hand U-
handle and fit it to the slot for rotation prevention of
right hand U-handle.
Fit grip assembling bolt and secure the grip firmly.
Right hand grip assembly
Grip assembling bolt
HANDLE
Bolts
Slot
Right hand U-handle
Bolt retainer tube
Handle assembling bolt (8 mm)
Left handle
Handle assembling bracket (lower)
To engine