Filter
Top Products
24
Drive Shaft Assembly
Level 1.
NOTE
Hedge Clipper drive shaft should be greased every 25 hours of
operation.
Tools required: 4 mm hex wrench, clean rag, small brush.
Parts required: POWER BLENDX
TM
14 oz. cartridge P/N 91015 or
Lithium Based Grease.
WARNING
Hedge Clipper blades are very sharp. Touching them may lead to
severe personal injury. Avoid touching blades whenever possible,
and always wear gloves to protect hands.
1. Remove gear housing locating screw (A) and clamping screw (B).
Remove the gear housing assembly from the drive shaft housing.
2. Pull the drive shaft (C) from the housing, wipe clean and re-coat
with a thin coating [1/2 oz. (15 ml)] of grease.
3. Slide the exible shaft back in the drive housing being careful not
to get dirt on the ex shaft.
4. Install the gear housing assembly.
IMPORTANT
Flat edge of washer (D) must be against drive shaft.
A
B
C
D