Filter
Top Products
Sh a f t he d g e Cl i p p e r
11
Op e r a t O r 'S Ma n u a l
NOTICE: Use of unmixed, improperly mixed, or fuel older than 90 days, (stale fuel), may cause hard starting, poor
performance, or severe engine damage and void the product warranty. Read and follow instructions in the Storage
section of this manual.
f u e l
g e a r h o u s I n g a s s e m b l y / d r I v e s h a f t
NOTE
Hedge Clipper Blades are very sharp. Wear gloves to protect
hands.
1. Remove locating bolt (A) and loosen clamping bolt (B).
2. Remove vinyl cap from drive shaft.
3. Slide Gear Housing Assembly onto Drive Shaft. Be certain the
Flex Drive Shaft engages the hole in Driver Gear.
IMPORTANT
Flat edge of washer (C) must be against drive shaft.
4. Align locating hole in gear housing with locator hole in drive
shaft.
5. Install locating bolt (A). Tighten clamping bolt (B).
A
B
C
op e r a t I o n
WARNING
Operation of this equipment may create sparks that can start res around dry vegetation. This unit is equipped with
a spark arrestor and a spark arrestor may be required. The operator should contact local re agencies for laws or
regulations relating to re prevention requirements.
WARNING
Moving parts can amputate ngers or cause severe injuries. Keep hands, clothing and loose objects away from all
openings. Always stop engine, disconnect spark plug, and make sure all moving parts have come to a complete stop
before removing obstructions, clearing debris, or servicing unit.