Filter
Top Products
He d g e Cl i p p e r
Op e r a t O r 's Ma n u a l
23
1. Disconnect spark plug wire from spark plug.
2. Slide blades to allow le clearance using slots (A) on bottom of
blades. Do not pry against cutting edges.
3. Follow the original shape, and le each cutting edge carefully to
avoid damage to adjacent teeth. Maintain 6 mm (.25 in.) radius at
base of each tooth.
IMPORTANT
If a power grinder is used, DO NOT allow blade to over heat.
4. Lubricate blades. See "Lubrication".
5. Connect spark plug wire.
b l a d e a d j u s t m e n t
Level 2.
Tools Required: 8 mm Socket & Extension, 4mm Hex Wrench w/
extension
1. Move stop switch to STOP position.
2. Disconnect spark plug wire.
WARNING
Hedge clipper blades are very sharp. Touching them may lead to
severe personal injury. Use long hex wrenches and sockets with
extensions when tightening blade screws and blade locknuts to keep
hands at a safe distance from sharp blades.
3. Tighten blade screws (A) securely.
4. Hold blade screws (A) to prevent turning, and tighten locknuts (B).
A
B
A
A
A
B