Filter
Top Products
22
Drive Shaft Assembly
Level 1.
NOTE
Hedge Clipper drive shaft should be greased every 25 hours of
operation.
Tools required: Torx T27 L-Wrench, screwdriver, clean rag, small
brush
Parts required: POWER BLENDX
TM
14 oz. cartridge or Lithium
Based Grease
WARNING
Hedge Clipper blades are very sharp. Touching them may lead to
severe personal injury. Avoid touching blades whenever possible,
and always wear gloves to protect hands.
1. Remove gear housing locating screw (A) and clamping screw (B).
Remove the gear housing assembly from the drive shaft housing.
2. Pull the drive shaft (C) from the housing, wipe clean and re-coat
with a thin coating [1/2 oz. (15 ml)] of grease.
3. Slide the drive shaft back in the drive housing being careful not to
get dirt on the ex shaft.
4. Install the gear housing assembly.
IMPORTANT
Flat edge of washers (D) must be against drive shaft.
s h a r p e n I n g b l a d e s
Level 2.
Tools required: Flat le, screwdriver
Parts required: None
WARNING
Hedge Clipper blades are very sharp. Touching them may lead to
severe personal injury. Avoid touching blades whenever possible,
and always wear gloves to protect hands.
C
A
B
D