Filter
Top Products
49
GLOSSARY
Cotter Pin A fastening device used to retain hex nuts on threaded shafts.
Also called a split pin.
Cultivator Attachment A rotating work attachment used on Power Attachment Series
units. Rotating tines cultivate and break up soil for weeding,
planting seeds, and working mulch into the soil.
Cut-Off Knife A cutting device attached to a plastic debris shield that cuts
nylon trimming line to the correct length.
Cutting Head A device that is designed to cut material by means of a nylon
line head, metal or nylon blades, or rotating saw chain.
Danger Zone An area around the operator where there is a high risk of injury
from contact with flying debris or sharp cutting head/work
attachments.
Debris Shield A plastic or metal barrier that helps protect an operator from
being struck by debris when using outdoor power equipment.
Edger A device with rotating blade that cuts a clean, straight edge.
Normally used along the edge of hard surfaces, such as be-
tween the lawn and a sidewalk.
Face Mask Protective device worn over mouth and nose. Protects against
breathing sawdust or other small particles.
Face Shield Protective device worn over safety glasses or safety goggles
to provide face protection from flying debris.
Foot Protection Heavy-duty footwear that helps protect feet from injury.
Front Handle Provides secure support of unit for proper balance and control.
Helps reduce operator fatigue.
Fuel Filter Filter element located on end of fuel line. Filters fuel mix
before it enters carburetor.
Fuel Tank Contains fuel mix used for engine operation.
Gear Case Provides rotating or reciprocating motion to a cutting head or
work attachment.
Goggles, Safety Protective eyewear that fits over glasses and provides com-
plete, wrap-around protectionl
Grass Trimmer A unit designed to cut only grass and light weeds.
Grass/Weed Blade A blade used to cut soft, light vegetation, such as grass and
weeds. Not for use in clearing brush, saplings, or small trees.
GT Grass Trimmer (Curved Shaft). GT models cannot use a metal
blade.
Harness An adjustable shoulder strap used to support a trimmer or
brushcutter. Helps operator control unit by providing a stable
support and reducing fatigue. Required for all Brushcutter
applications.