Filter
Top Products
14
Debris Shield
WARNING
Plastic Debris Shields are equipped with a sharp cut-off
knife for cutting nylon trimmer line to length during op-
eration. Use extreme care when assembling nylon line
head to gear case to avoid accidental contact with cut-
off knife. Wear work gloves when assembling nylon line
head to gear case, and avoid contact with sharp cut-off
knife edges.
Unit Configuration
GT Models: If your Model GT curved shaft trimmer is
not fully assembled, you must assemble the unit as
instructed in the Operator’s Manual provided with the
unit. Before using the unit, make sure the plastic debris
shield, trimmer head, and handle are properly attached,
and are securely fastened.
If your GT curved shaft trimmer has been pre-as-
sembled, you must make sure the plastic debris shield,
handle, and trimmer head are properly installed and
securely attached, as shown in the Operator’s Manual
provided with the unit.
DANGER
NEVER install a metal blade on a model GT curved
shaft trimmer. Use of any metal blade on a GT curved
shaft trimmer can result in serious injury to operator and
bystanders. Use only nylon line heads or GT series
Maxi-Cut plastic weed trimmers approved for use on GT
models by Echo. (See Set-up Guide page 15)
ASSEMBLY
Front Handle
GT Debris
Shield
Trimmer Head
GT MODEL
Cut-Off Knife
SRM Debris Shield
GT Debris Shield
Cut-Off
Knife
NO Metal
Blades