Filter
Top Products
18
Read the Safety Section on pages 3 - 6 carefully.
IMPORTANT
To avoid engine damage due to over-revving, do not block
blower pipe opening.
1. Use only during appropriate hours.
2. Allow the engine to warm up at a fast idle for a few minutes.
3. PB-770H
Set engine speed with throttle lever (A).
PB-770T
Control engine speed with throttle trigger (B), or for continuous
use, set engine speed with Combination Throttle Position / Stop
Switch Button (A).
4. Use lower speed to blow dry leaves from walks, patios and drives.
5. Additional speed may be necessary to clean grass and leaves from
a lawn or flower bed.
6. Higher speed may be necessary to move gravel, dirt, snow, bottles
or cans from a driveway, street, parking lot or stadium.
7. Always stop unit using stop engine procedure.
NOTE
Never use a higher speed setting than necessary to perform a task.
Remember, the higher the engine speed, the louder the blower
noise. Minimize dust by using blower at lower speeds and by
dampening material with water/mist when necessary. Keep debris
on your property.
Be Smart - be a good neighbor.
WARNING
Always wear safety glasses, hearing protection, a face filter mask and take all safety precautions or serious per-
sonal injury may result.
Do not point the blower pipe in the direction of people or pets.
OPERATING BLOWER
PB-770T
B
A
A
PB-770H
WARNING
Engine exhaust IS HOT, and contains Carbon Monoxide (CO), a poison gas. Breathing CO can cause uncon-
sciousness, serious injury, or death. Exhaust can cause serious burns. ALWAYS position unit so that exhaust is
directed away from your face and body.
IMPORTANT
Use reduced speed only when performing light-duty tasks or to comply with local noise regulations. Continuous
low speed operation may allow fuel/oil residue to build-up on the piston and cause rapid build-up of carbon on
the spark arrestor screen, resulting in overheating and engine damage. To reduce harmful build-up, run engine at
wide open throttle for at least 5 minutes every hour, and inspect/clean the spark arrestor screen after approxi-
mately 40 hours of operation.