Filter
Top Products
12
ASSEMBLY
PB-770H
WARNING
Never perform maintenance or assembly procedures with engine
running or serious personal injury may result.
INSTALL BLOWER PIPES / STICK HANDLE (H)
1. Assemble clamps (A) onto both ends of flexible pipe (B).
2. Assemble swivel pipe (C) into flexible pipe (B) and tighten clamp
(A).
3. Insert anti-static wire through flexiblepipe (B).
4. Assemble flexible pipe (B) to elbow (D) on blower and tighten
clamp (A).
NOTE
A light lubricant may be used to ease assembly of flexible pipe to
blower elbow.
5. Loosen wing nut (E). Align notches (G) in handle clamp with tabs
(H).
6. Slide stick handle onto swivel pipe (C). Stick handle (F) should be
angled away from operator.
7. Position stick handle (F) over metal plate on swivel pipe and adjust
for comfortable operation. Tighten wing nut (E).
NOTE
Ground lead of stick handle must contact metal plate on swivel pipe.
8. Assemble straight pipe (J) onto swivel pipe (C), until you feel light
resistance. Do not force connection. Hold swivel pipe and turn
straight pipe clockwise, engaging positive locking channels, until
connection is firm. Do not force connection.
9. Assemble straight pipe with decal (K) to straight pipe (J) as in step
8.
NOTE
Blower use will eventually loosen pipe connections. Exclusive
positive locking system allows pipes to be tightened. If loosening
occurs, remove two straight pipes and install according to
instructions 8 & 9.
B
A
J
K
C
D
A
A
B
C
F
C
E
G
H
B