Filter
Top Products
HEDGE CLIPPER
OPERATOR'S MANUAL
9
Operation (HCA)
• Never adjust blade angle of HCA while standing.
• Only adjust cutting angle with HCA resting flat on the ground, with
the engine stop switch in the "STOP" position.
• Adjust cutting angle by moving locking lever (A) up. Depress blade
indexing lever (B) and change blade angle with rear cutter assembly
handle. Release indexing lever (B) into notch. Move locking lever (A)
down to completely engage internal gears.
IMPORTANT
Lever (A) does not secure gearbox angle setting. Moving lever in
the down position reduces internal play in the gear box. Do not
over tighten castle nut (C) to insure gear box angle setting
tightness because damage to internal gears will occur. If the lever
is loose or very tight adjust nut (C) for snug 90° movement.
A
B
C