Filter
Top Products
24
b l a d e a d j u s T m e n T
Level 2.
Tools Required: Long 4 mm hex wrench, 8 mm socket wrench
with extension.
1. Move stop switch to STOP position.
2. Disconnect spark plug wire.
WARNING
Hedge clipper blades are very sharp. Touching them may lead to
severe personal injury. Use long hex wrenches and sockets with
extensions when tightening blade screws and blade locknuts to keep
hands at a safe distance from sharp blades.
3. Tighten blade screws (A) securely.
4. Hold blade screws (A) to prevent turning, and tighten locknuts (B).
A
B
1. Move stop switch to stop position.
2. Disconnect spark plug wire.
3. Remove blade stiffener. (See “Blade Stiffener Remove/Install
instructions”)
4. Slide blades to allow le clearance using slots (B) on bottom of
blade. Do not pry against cutting edges.
5. File each edge carefully. Follow the original shape of the blade.
IMPORTANT
If a power grinder is used DO NOT allow blade to over heat.
6. Install blade stiffener. (See “Blade Stiffener Remove/Install instruc-
tions”)
7. Lubricate blades (see “Lubrication instructions”).
IMPORTANT
Blades should only be removed and reinstalled by an Authorized
ECHO Servicing Dealer, otherwise premature wear or internal
gearcase damage may occur.
A
6mm (.25 in.) Radius
B
45º