Filter
Top Products
14 X7702094205
© 09/2013 ECHO Inc.
ASSEMBLY GT-230
To Advance Trimmer Line
See Maintenance Section for nylon line replacement.
Note: To advance trimmer line, tap trimmer head against the ground while the head is turning at normal
operating speed.
Remove Nylon Line Head
Note: Do not disassemble nylon line head.
1. Align locating hole in upper plate with hole in bearing
housing and insert 5 mm (3/16 in.) diameter locking tool (D).
2. Remove line head by turning it counter clockwise until head
is completely off of shaft.
3. Remove locking tool (D).
Support Handle
Note: Label shows minimum spacing for support handle
location.
Note: Support handle is pre-installed. Re-positioning and
tightening is all that is required.
1. Position support handle (E) in comfortable operating
position and tighten wing nut (F). The cutting attachment
should be 5-7.5 cm (2-3 in.) above the ground and as level
as possible.
D
E
F