Filter
Top Products
GT-230 ASSEMBLY
X7702094205 13
© 09/2013 ECHO Inc.
ASSEMBLY
Plastic Shield Installaion
Cut-off knife on debris shield has sharp edges. Avoid contact when installing or removing line head.
Wear Gloves or personal injury may result:
◆ Cutoff knife is sharp.
◆ Gearcase and surrounding area may be hot.
1. Remove wing nut (A), washer (B), and bolt (C).
2. Snap the shield over the bearing housing.
3. Install bolt (C), washer (B), and wing nut (A).
Nylon Line Head Installation
1. Remove plastic threaded shaft sleeve from threaded PTO
shaft.
2. Align locating hole in upper plate with hole in bearing
housing and insert 5 mm (3/16 in.) diameter locking tool (D).
3. Thread cutting attachment onto shaft clockwise until head is
tight.
Remember to remove the locking tool.
Semi-automatic nylon line heads must be used only with plastic debris shield with cut-off knife.
Parts Required: Nylon Trimmer Head, Plastic Shield
Assembly.
C
B
A
D