Filter
Top Products
10
ASSEMBLY
PLASTIC
SHIELD
Tools Required: None
1. Remove wing nut (C), washer (B), and bolt (A).
2. Snap the shield over the bearing housing.
3. Install bolt (A), washer (B) and wing nut (C).
NYLON LINE HEAD
Tools Required: Head Locking Tool, 9/16 in. Socket
Parts Required: Rapid Loader
TM
Head.
1. Remove plastic threaded shaft sleeve from PTO shaft.
2. Align locating hole in upper plate with hole in bearing housing and
insert 1/8 in. diameter locking tool (A).
3. Place large washer then line head on threaded shaft followed by
small metal washer and locknut.
4. Tighten locknut securely.
IMPORTANT
Remember to remove the locking tool.
A
B
C
A