Filter
Top Products
21
Sh r e d 'N'Va c
®
O
p e r a t O r 'S Ma N u a l
e x h a u s T
s y s T e m
Spark Arrestor Screen
Level 2.
Tools required: Cross Head Screwdriver, 4 mm Hex Wrench, Soft
metal brush
Parts Required: Spark arrestor screen, Gasket
1. Remove engine cover (two screws), pull cover away from engine.
Clean cylinder ns with brush to allow cooling air to pass freely.
2. Remove spark arrestor cover (A), deector (B), plate (C), gasket
(D), and spark arrestor screen (E) from mufer. Replace screen if
plugged with carbon deposits.
NOTE
When cleaning carbon deposit, be careful not to damage the cata-
lytic element inside mufer.
3. Install spark arrestor screen, gasket, plate, deector, and cover.
4. Loosely reassemble engine cover with two screws.
5. Tighten all screws securely.
A
B
D
C
Cleaning Cylinder Fins
1. Remove engine cover (two screws), pull cover away from engine.
Clean cylinder ns to allow cooling air to pass freely.
2. Loosely reassemble engine cover with two screws.
3. Tighten all screws securely.
E