Filter
Top Products
7
7
102514
SAW CHAIN TENSION
ADJUSTMENT
Note:
A new chain will stretch. Check new chain after first
few minutes of operation. Allow chain to cool down. Follow
steps below to readjust saw chain tension.
1. Before adjusting chain, make sure guide bar nuts are only
finger tight (see Figure 3, page 6). Also make sure adjust-
ing block is in oval adjusting hole on guide bar (see Figure
3 and 4, page 6).
2. Turn adjusting screw clockwise until all slack is out of
chain (see Figure 5).
Note:
There should be no gap between side links of chain
and bottom of guide bar (see Figure 6).
Figure 5 - Turning Adjusting Screw
!
WARNING ICON G 001
WARNING
Unplug chain saw from power source before
adjusting saw chain tension.
!
WARNING ICON G 001
WARNING
Cutting edges on chain are sharp. Use protective
gloves when handling chain.
!
WARNING ICON G 001
WARNING
Maintain proper chain tension always. A loose
chain will increase the risk of kickback. A loose
chain may jump out of guide bar groove. This
may injure operator and damage chain. A loose
chain will cause chain, guide bar, and sprocket
to wear rapidly.
FILLING OIL TANK
1. Remove oil cap.
2. Fill oil tank with Echo bar and chain oil.
3. Replace oil cap at once. Tighten oil cap firmly for good
seal. This will avoid oil seepage from tank.
4. Wipe off excess oil.
Note:
It is normal for oil to seep when saw is not in use.
Empty oil tank after each use to prevent seepage.
Guide Bar
Incorrect Tension
Figure 6 - Saw Chain Adjustment
Guide Bar
Nuts
Guide Bar
Gap
Correct
Tension
3. Wearing protective gloves, move chain around guide bar.
Chain should move freely. If chain does not move freely,
loosen chain by turning adjusting screw counterclockwise.
4. After chain tension is correct, tighten guide bar nuts firmly.
If not, guide bar will move and loosen chain tension. This
will increase the risk of kickback. This can also damage
saw.
Note:
A new chain will stretch. Check new chain
after first few minutes of operation. Allow chain to cool
down. Readjust chain tension.
!
WARNING ICON G 001
WARNING
Read and understand this owner’s manual
before operating this saw. Make certain you read
and understand all Safety Warnings. Improper
use of this chain saw can cause severe injury or
death from fire, electrical shock, or body contact
with moving chain, or falling wood.
OPERATING CHAIN SAW
Continued