Filter
Top Products
13
CS-500P
HANDLING FUEL
MIXING INSTRUCTIONS -
1. Fill an approved fuel container with half of the
required amount of gasoline.
2. Add the proper amount of two-stroke oil to
gasoline.
3. Close container and shake to mix oil with
gasoline.
4. Add remaining gasoline, close fuel container,
and remix.
IMPORTANT
s3PILLEDFUELISALEADINGCAUSEOFHYDROCARBON
emissions.
Some states may require the use of automatic
fuel shut-off containers to reduce fuel spillage.
s3TOREDFUELAGES
Do not mix more fuel than you expect to use in
thirty (30) days, ninety (90) days when a fuel
stabilizer is added.
s3TOREDTWOSTROKEFUELMAYSEPARATE
Always shake fuel container thoroughly before
each use.
AFTER USE -
Do not store a unit with fuel in its tank. Leaks can
occur. Return unused fuel to an approved fuel
storage container.
STORAGE -
Fuel storage laws vary by locality. Contact your
local government for the laws affecting your area.
As a precaution, store fuel in an approved, airtight
container. Store in a well-ventilated, unoccupied
building, away from sparks and flames.
DANGER
Fuel is very flammable. Use extreme care
when mixing, storing or handling or serious
personal injury may result.
s5SEANAPPROVEDFUELCONTAINER
s$ONOTSMOKENEARFUEL
s$ONOTALLOWmAMESORSPARKSNEARFUEL
s&UELTANKSCANSMAYBEUNDERPRESSURE
Always loosen fuel caps slowly allowing
pressure to equalize.
s.EVERREFUELAUNITWHENTHEENGINEISHOT
s.EVERREFUELAUNITWITHTHEENGINERUNNING
s$ONOTlLLFUELTANKSINDOORS
!LWAYSlLLFUELTANKSOUTDOORSOVERBARE
ground.
s3ECURELYTIGHTENFUELCAPAFTERREFUELING
s)NSPECTFORFUELLEAKAGE
If fuel leakage is found, do not start or
operate unit until leakage is repaired.
s-OVEATLEASTMFEETFROMREFUELING
location before starting the engine.
EMISSION DATA
EMISSION CONTROL
(EXHAUST and EVAPORATIVE) EPA 2010 and/
or C.A.R.B. TIER III
The emission control system for the engine is EM/
TWC (Engine Modification and 3-way Catalyst)
and for the fuel tank the Control System is EVAP
(Evaporative Emissions) or N (for nylon tank).
Evaporative emission may be applicable to
California models only.
An Emission Control Label is located on the
engine. (This is an example only, information on
label varies by engine family).
PRODUCT EMISSION DURABILITY
(EMISSION COMPLIANCE PERIOD)
The 300 hours emission compliance period is
the time span selected by the manufacturer
certifying the engine emissions output meets
applicable emissions regulations, provided that
approved maintenance procedures are followed
as listed in the Maintenance Section of this
manual.
EMISSION CONTROL INFORMATION
ENGINE FAMILY: #EHXS.0505RC DISPLACEMENT: 50.2 cc
EMISSION COMPLIANCE PERIOD: 300 Hours
THIS ENGINE MEETS U.S. EPA EXH/EVP EMISSION
REGULATIONS FOR MODEL YEAR **** REFER TO OWNER’S MANUAL
FOR MAINTENANCE SPECIFICATIONS AND ADJUSTMENTS.
***????