Filter
Top Products
8
CS-370
PREPARATION FOR USE
GUIDE BAR AND SAW CHAIN
INSTALLATION/REMOVAL
KICK GUARD
®
TO BAR
INSTRUCTIONS
Tools Needed: Two 11 mm Wrenches.
For saws with Kick Guard
®
P/N 2893201 and
Symmetrical Low-Kick type (Double Guard)
guide bars.
1. Install bolt (A) in
rear
hole (B) of Kick Guard
®
and through front hole (C) in guide bar.
2.
IMPORTANT: Dimple (D) in Kick Guard
®
must
engage recess (E) in guide bar.
3. Tighten nut (F) and bolt (A) using 11 mm
wrenches until snug. Make certain Kick Guard
®
is flush against guide bar.
4. Tighten nut (F) 1/8 additional turn.
5. Check to make certain Kick Guard
®
is tight on
guide bar.
Bolt (A)
Dimple (D)
Recess (E)
Front hole (C)
Rear
hole (B)
Nut (F)
Guide bar
Kick Guard
®
WARNING
SAW CHAIN IS SHARP! ALWAYS WEAR
GLOVES WHEN HANDLING ASSEMBLY,
OTHERWISE SERIOUS PERSONAL INJURY
MAY RESULT.
NOTE
Move chain brake lever (Front hand guard,
Brake connector) fully rearward to remove or
install the clutch cover to the chain saw.
1. Remove spark plug lead. (See page 20)
2. Remove two clutch cover nuts and remove clutch
cover.
3. Remove bar and saw chain if necessary. See
“Maintenance and Care” section for guide bar/
saw chain maintenance procedures.
Brake connector
Clutch cover
Brake lever
(Front hand guard)
Two nuts