Filter
Top Products
28
TESTING THE BRAKE
• Start the engine on a solid level surface and run at a fast
idle until warm.
• Hold the saw rmly by the handles and accelerate the en-
gine to a fast idle.
• Slowly operate the chain brake lever while holding the saw
rmly on the ground. When the brake lever trips, the chain
should stop. Immediately release the throttle trigger.
IMPORTANT
Do not allow the saw to tip forward in order to
avoid damage to the chain.
If the chain does not stop, immediately return the saw to your
authorized Echo dealer for repair.
INSTALLATION
• Echo recommends that the chain brake should be serviced
by an authorized Echo servicing dealer.
OPERATION
• Set the lever in the released position before starting to cut.
• If the brake is tripped by kick back reaction, the chain will
stop. Immediately release the throttle to avoid possible
damage to the engine or clutch.
• Do not attempt to operate the engine with the brake en-
gaged.