Filter
Top Products
24
WARNING
Use of replacement saw chain and/or guide bar other than that specied, or operation without the “tip guard” in place,
may cause severe kickback resulting in serious injury.
Only use saw chain designated as, “LOW-KICKBACK,” that meets the ANSI B175.1-2000 Standard when tested on
the representative sample of chain saws below 3.8 C.I.P. specied, and the Echo guide bar specied.
IMPORTANT
Chain and guide bar gauge size must be identical. Use Bar/Chain combinations shown in table
above.
IMPORTANT
If your kick guard is damaged or lost, contact your Echo dealer for a replacement. For the name
of the Echo dealer nearest you, Call: 1-800-432-ECHO (3246) or on the web at www.echo-usa.
com.
Refer to your Chain Saw Safety Manual for kick guard application information.
For setting saw chains, round le (4 mm ø: 5/32”) and at le are used.
• To keep correct position and correct angle, use the le holder.
- Round le and at le are available from your Echo Dealer.
• File cutters as below.
Type : 91VG
HOLD FILE HOLDER
LEVEL
Depth
gauge
ONE FIFTH OF FILE DIAMETER
REMAINS ABOVE CUTTER EDGE
To sharpen other type chain, follow chain manufacturer’s instructions
30°
PUSH FILE AS SHOWN
Keep this angle
1/5
90°
s e t t i n g t h e s a w C h a i n
Depth gauge
tool
Remove
until at
with tool
Round
off the
edge
• Place the depth gauge tool rmly on guide bar so that depth gauge protrudes. Then le top of depth gauge with at
le until at with top of the gauge tool.
- Be sure to round off the front edge of the depth gauge.