Filter
Top Products
19
*Reduced nose radius symmetrical bars (OREGON name — Double Guard)
WARNING DANGER
Use of replacement saw chain and/or guide bar other than that specified, or operation without the “tip guard” in place, may
cause severe kickback resulting in serious injury.
Only use saw chain designated as, “LOW-KICKBACK,” that meets the ANSI B175.1-2000 Standard, and the Echo guide
bar specified.
CHAIN AND GUIDE BAR COMBINATION
The following combinations may be used on CS-305.
Type : 90SG
HOLD FILE HOLDER
LEVEL
Depth
gauge
ONE FIFTH OF FILE DIAMETER
REMAINS ABOVE CUTTER EDGE
To sharpen other type chain, follow chain manufacturer’s instructions
30°
PUSH FILE AS SHOWN
Keep this angle
1/5
For setting saw chains, round file (4 mmø: 5/32”) and flat file are used.
• To keep correct position and correct angle, use the file holder.
- Round file and flat file are available from your Echo Dealer.
• File cutters as below.
SETTING THE SAW CHAIN
IMPORTANT
If your kick guard is damaged or lost, contact your Echo dealer for a replacement. For the
name of the Echo dealer nearest you, Call: 1-800-432-ECHO (3246) or on the web at
www.echo-usa.com.
Refer to your Chain Saw Safety Manual for kick guard application information.
LEDOM
RAB
HTGNEL
ELBUOD
RABDRAUG
NIAHCWAS
KCIK
DRAUG
N/POHCE
)N/PMEO(
OHCE
.ONTRAP
SKNILEPYTHCTIPEGUAG
N/POHCE
)N/PMEO
(
503-SC
"21
/105473421
)5473DC4A21(
540709154
GS09"8/3340.
1094982
94982
"41
/102573441
)2573DC4A41(
250709125
IMPORTANT
Chain and guide bar gauge size must be identical. Use Bar/Chain combinations shown in table
above.