Filter
Top Products
8
CONTENTS
The ECHO product you purchased has been factory pre-assembled for your convenience. Due to packaging restrictions,
shield installation and other assembly may be necessary.
After opening the carton, check for damage. Immediately notify your retailer or ECHO Dealer of damaged or missing
parts. Use the contents list to check for missing parts.
____ 1 - PAS Hi Torque Trimmer Attachment
____ 1 - Operator's Manual
____ 1 - Safety Manual
____ 1 - Warranty Registration Card
____ 1 - Locking Tool
____ 1 - T-Wrench
____ 1 - Plastic Debris Shield
____ 1 - Nylon Trimmer Head
____ 1 - Safety Goggle
____ 1 - Shield Plate
____ 3 - 5mm x 16mm Screws (shield mounting)
____ 1 - Storage Hook Assembly
Tools Required: None
Parts Required: PAS or SRM-SB Power Head w/Shaft & Coupling.
1. Set Power Head/Shaft Assembly on a level surface.
2. Pull locator pin (A) out, and turn counter-clockwise 1/4 turn to
lock-out position.
3. Remove vinyl cap from attachment drive shaft.
4. Carefully fit attachment drive shaft assembly into coupler (B) to
decal assembly line (C), making sure that the inner lower drive shaft
engages into the square upper drive shaft socket.
NOTE
Earlier model Power Heads may have shorter couplings. Short
couplings fit flush to decal point (E). New couplings are 4-3/4 in.
long, and fit flush to line (C).
NOTE
Lower bearing housing and head assembly must be in line with the
engine.
ASSEMBLY
POWER
HEAD SHAFT/LOWER SHAFT ASSEMBLY
A
B
D
E
C