Filter
Top Products
Po w e r Pr u n e r
TM
AT T A c h M e n T
oP e r A T o r 's MA n u A l
9
5. Rotate locator pin (A) 1/4 turn clockwise to engage lower shaft
hole. Insure locator pin is fully engaged by twisting lower drive
shaft. Locator pin should snap ush in coupler. Full engagement
will prevent further shaft rotation.
6. Secure lower shaft assembly to coupler by tightening clamping
knob (D).
f r o n t l o o p h a n d l e r e m o v a l
Tools Required: Screwdriver.
Parts Required: None
NOTE
Front loop handles/loop handles with barrier bars are not recom-
mended for use with Power Pruner attachment.
1. Remove front handle assembly, barrier bar (if installed), and mount-
ing hardware from PAS or SRM-SB power head.
2. Retain parts for future use.
s a w c h a I n t e n s I o n a d j u s t m e n t
Tools Required: 10 mm Wrench, Screwdriver
WARNING
Always wear gloves when handling saw chain, otherwise serious
personal injury may result.
To Adjust Saw Chain Tension.
1. Loosen two (2) guide bar nuts (A) located on cutting attachment.
2. Turn saw chain tensioner screw (B) clockwise to tighten saw chain
on guide bar. Turning screw counter clockwise will loosen saw
chain on guide bar.
3. Tighten guide bar nuts rmly. Move saw chain backwards on guide
bar by hand. Saw chain should move freely on guide bar if it is
in proper mesh with sprocket. If saw chain is difcult to rotate or
binds on guide bar, it is too tight.
Keep the saw chain lubricated and properly adjusted and the guide bar
nuts tightened rmly at all times.
A
B