Filter
Top Products
Po w e r Pr u n e r
TM
AT T A c h M e n T
oP e r A T o r 's MA n u A l
7
9
1
e q u I p m e n t
Before operation a complete check of the unit must be performed;
• Check unit for loose/missing nuts, bolts and screws. Tighten and/or replace as needed.
P/N X505001821
de s c r I p t I o n
Locate this safety decal on your attachment. Make sure the decal is legible and that you understand and follow the
instructions on it. If it cannot be read, a new one can be ordered from your ECHO dealer. See PARTS ORDERING
instructions for specic information.
1. GRIP, FRONT - Cushioned grip for left hand.
2. SHAFT DECAL - Contain important safety information that must be followed.
3. LOWER DRIVE SHAFT ASSEMBLY - Contains a specially designed liner and the exible drive shaft.
4. CUTTING ATTACHMENT - Sealed, gear ratio is 1.5:1 reduction.
5. AUTOMATIC OILER ASSEMBLY - Self oiling. Use high quality, low viscosity, non detergent bar and chain oil.
6. SAW CHAIN - 91 VX 9.53mm (3/8 inch) low prole Oregon® saw chain. Runs approximately 725 m/min.
(2378 ft/min) at 6500 RPM.
7. GUIDE BAR - 254 mm (10 inch) Bar
8. CUTTING SHOE - Used to capture and stabilize branch while cutting. Place cutting shoe against branch, accelerate
and lower saw chain into branch.
9. GUIDE BAR COVER - Used to cover guide bar and saw chain during transport and storage. Remove guide bar
cover before using unit.
WARNING
Moving parts can amputate ngers or cause severe injuries. Keep hands, clothing and loose objects away from all
openings.
• ALWAYS stop engine, disconnect spark plug, and make sure all moving parts have come to a complete stop
before removing obstructions, clearing debris, or servicing unit.
• DO NOT start or operate unit unless all guards and protective covers are properly assembled to unit.
• NEVER reach into any opening while the engine is running. Moving parts may not be visible through openings.