Filter
Top Products
10
s k I l l l e v e l
Level 1 = Easy to do. Common tools may be required.
Level 2 = Moderate difculty. Some specialized tools may be required.
m a I n t e n a n c e I n t e r v a l s
Component/System Maintenance Procedure Skill Level Frequency
Drive Shaft Grease 1 Every 25 hours of use
Gear Housing Grease 1 Every 15 - 25 hours of use
Screws/Nuts/Bolts Inspect/Tighten/Replace 1 Before each use
b l a d e r e p l a c e m e n t /l u b r I c a t I o n
Level 1.
Tools Required: T-Wrench, Locking Tool, Needle Nose Pliers, 13 mm
Open End Wrench
Parts Required: POWER BLENDX
TM
8 oz. (P/N 91014) or Lithium
Base Grease, Blade P/N 69601552632, split pin P/N
90030020022
Gear Case
NOTE
Grease gear case every 15 - 25 hours of use. Replace blade when it
is worn shorter than 6 in. Remove blade and holders before greasing
to prevent damage to gear and bearings.
1. Shut engine off.
2. Remove split pin (A).
3. Rotate blade until holes in inner blade adapter (B) and gear box
align. Insert locking tool to lock PTO shaft (C).
NOTE
Blade nut (D) is left hand thread.
4. Remove blade nut (D) in a clockwise direction using scrench. Re-
move outer blade adapter (E), blade (F) and inner blade adapter (B).
B
C
E
F
A
D