Filter
Top Products
16
When your spa is first powered up, it will automatically heat and
maintain 100 F until you change the set temperature.
The current temperature is constantly displayed on the LCD. Press either
or pad once to display the set temperature. (The temperature
is designated by a triangle in the upper left corner.) Each time either pad is
pressed, the set temperature will increase or decrease depending upon
which pad is pressed. After three seconds, the LED will automatically display
the current spa temperature.
Press the JETS 1 pad to activate the low speed of pump 1. Press the pad
again for the high speed of pump 1. Press the JETS 2 pad again to turn off
the pump. The low-speed pump runs when a filter cycle is activated or
when a freezing condition is detected. If automatically activated, the low-
speed cannot be disabled from the front panel; however, the high-speed
pump may be started. The low- speed of pump 1 turns off after 2 hours, and
the high-speed pump turns off after 20 minutes.
Temperature Adjustment
Jets 1
Press the JETS 2 pad to activate the low speed of pump 2. Press the pad
again for the high speed of pump 2. Press the JETS 2 pad again to turn off
the pump. Both speeds of the pump turns off after 20 minutes.
Jets 2
Top Side Control Instructions
D - 3000 System
auxiliary panel (optional)
Initial Start-up
D - 3000 System