Filter
Top Products
8) Helpful Tips
• Clean filter bag whenever you remove the DOLPHIN from the pool. A dirty bag can become dry and unusable.
• Ensure pH level of pool water [optimally 7.0 - 7.4].
• Ensure correct chlorine level of pool water [optimally 2 to 4 ppm].
• Ensure an ideal water temperature [54
°
F to 90
°
F] [12
°
C - 32
°
C].
• Ensure that the brushes [16 page-10] are in good condition.
• Always switch the float button
‘OFF’
, wait 10 seconds and switch ‘START’ again to start a new cleaning cycle.
• Store the DOLPHIN upright on the Caddy – not on its brushes – in the shade at a temperature of 41
°
F to 77
°
F
[5
°
C to 25
°
C]. Coil the cable loosely around the Caddy hooks [Fig M].
• Note that cool or cold temperatures will lengthen the battery lifespan.
• It is recommended to use the attached factory supplied DOLPHIN cover to protect the DOLPHIN from sunlight.
• Call your local dealer if troubleshooting advice is needed.
• Wonder brushes or combined brushes should be thoroughly washed and squeezed.
• To prolong Wonder brushes longevity, it is recommended that they be kept wet at all times even when stored
for a long period of time.
• When first used, the DOLPHIN may climb too high and suck in air when it reaches the waterline.
If so, remove the handle floats [17 page-10] by pushing them downward [Fig N].
• Ask your dealer about optional coarse and/or disposable filter bags.
• For troubleshooting go to www.maytronicsus.com.
9) General specifications
Calculated Ground Speed
Calculated Scanning Rate
Suction Rate [self controlled]
Weight
Charger
Input Voltage
Output Voltage
Rated output
These specifications may vary for different swimming pools and for the various electrical configurations.
Although the DOLPHIN has been tested in a wide range of swimming pools, MAYTRONICS cannot accept
responsibility if the DOLPHIN is not entirely suitable for any particular swimming pool.
Note:
The sealed motor unit and the DOLPHIN charger contain no user-serviceable parts.
Opening these units will automatically invalidate your warranty.
The manufacturer reserves the right to change these specifications without prior notice.
U.S. Patent No. 4168557. S.A. Patent No. 76/7474. AUST Patent No. 509698.
100 VAC / 115 VAC / 230 VAC
30 VDC - nominal
160 W
50 ft/min
63 ft
2
/min
79 gal/min (USA)
29 lb
8
Fig
N
[25˚C]
[5˚C]
77˚F
41˚F
M
Fig
900 m/hr
350 m
2
/hr
18,000 l/hr
13.2 kg