Filter
Top Products
26
Starting the engine
Start the chain saw only after having assembled it com-
pletely and inspected.
Move at least 10 feet (3m) away from the place where you
fuelled the saw.
Make sure you have a good footing, and place the saw on the
ground in such a way that the chain is not touching anything.
Engage the chain brake (lock).
Hold the tubular handle tightly with one hand and press the
chain saw to the ground.
Steady the rear handle by standing in the hand guard.
132 4
6 5
A
Checking the chain brake
Donotworkwiththechainsawwithoutrstcheckingthe
chain brake!
Start the engine as described (make sure you have a good
footing, and place the chain saw on the ground in such a way
that the guide bar is free of contact).
Grasp the tubular handle rmly with one hand and hold the grip
with the other.
With the engine running at moderate speed, press the
hand guard (7) in the direction of the arrow with the back of
your hand until the chain brake engages. The chain should
stop immediately.
Immediately release the throttle and release the chain brake.
IMPORTANT: If the chain does not stop immediately when
you test the chain brake, do NOT use the chain saw. Take
the chain saw to a DOLMAR service center.
7
C
B
Cold-starting:
Pull the choke (1) out until it audibly clicks. This simultane ously
actuates the half-throttle lock.
Move the I/STOP ignition switch (3) as shown by the arrow.
Slowly pull out the starter cable until you notice resistance
(the piston is positioned before the top dead center).
Push the decompression valve (2) (option).
Now pull the starter cable with a fast and forceful movement
untilyouheartherstignition.
CAUTION: Do not pull out the starter cable more than approx.
50 cm, and lead it back by hand.
Push the decompression valve (2) (option).
Depress the choke (1) and pull the starter cable again. As
soon as the engine is running, grasp the rear handle (this actuates
the throttle stopper (5)) and tap the throttle lever (6). This will
release the half-throttle lock and the engine will run in idle.
CAUTION
: As soon as the engine is started it must be put
in idle to prevent the chain brake from being damaged.
Now release the chain brake.
Warm starting:
As described for cold starting, except before starting pull the
choke (1) all the way out and back in one time, in order to ac-
tivate the half-throttle lock.
Stopping the engine
Move the I/STOP ignition switch to
the “STOP” position.