Filter
Top Products
8
Chain saw operating instructions
For assembly follow the procedure in the appropriate
section "Mounting Guide Bar and Chain" of this manual.
DOLMAR chain, guide bar and sprocket must match each
other (see the appropriate section in this manual).
WARNING!
Proper tension of the chain is extremely important. In
order to avoid false setting the tensioning procedure
must be followed as described in this manual. Always
make sure the hexagonal nut(s) for the sprocket
guard is (are) tightened securely after tensioning
the chain. Check chain tension once more after
having tightened the nuts and thereafter at regular
intervals (always before starting to work). If the chain
becomes loose while cutting, shut off the engine and
then tighten. Never try to tighten the chain while the
engine is running!
Fueling
Your DOLMAR saw uses on oil-gasoline mixture for fuel
(see chapter "Fuel" of this manual).
5a
Wipe off any spilled fuel before starting your saw and
check for leakage.
Check for fuel leakage while refueling and during opera-
tion. If fuel or oil leakage is found, do not start or run
the engine until leak is xed and spilled fuel has been
wiped away. Clothing with fuel on it has to be changed
immediately (this is a danger to your life!).
Avoid skin contact with fuel. Never loosen or remove the
cap of the fuel tank while the engine is running.
Starting
Do not drop start. This method is very dangerous be-
cause you may lose control of the saw (g. 6).
WARNING!
Gasoline is an extremely ammable fuel. Use ex-
treme caution when handling gasoline or fuel mix.
Do not smoke or bring any sparks or ame near the
fuel (g. 5).
Fueling instructions
Fuel your chain saw in well ventilated areas or out-
doors. Always shut off the engine and allow it to cool
before refueling. Select bare ground for fueling and
move the chain saw at least 10 feet (3 m) from fueling
spot before starting the engine (g. 5a).
6a
6
Place the chain saw on rm ground or other solid surface
in an open area. Maintain a good balance and secure
footing. Place your right foot through the rear handle
opening and rmly grasp the front handle with your left
hand (g. 6a).
Be absolutely sure that guide bar and chain are clear of
you or all other obstructions and objects, including the
ground, because when the engine starts in semi-throttle
position, engine speed will be fast enough for the clutch
to engage the sprocket and turn the chain which may
cause a kickback.
Never attempt to start the saw when the guide bar is
in a cut or kerf.
When you pull the starter grip, don’t wrap the starter
rope around your hands. Do not allow the grip to snap
back, but guide the starter rope slowly back to permit the
rope to rewind properly. Failure to follow this procedure
may result in injury to hand or ngers and may damage
the starter mechanism.
5
10 feet