Dolmar MS-250.4, MS-251.4 Brush Cutter User Manual


 
14
For machine with U Handle or Loop Handle
1) Set the I-O switch (1) to OPERATION.
2) Choke lever
Close the choke lever.
Choke opening:
Full closing in cold or when the engine is cold.
Full or half opening in restart just after stop of operation.
3) Primer pump
Continue to push the primer pump until fuel enters into the primer pump. (In
general, fuel enters into the primer pump by 7 to 10 pushes.)
If the primer pump is pushed excessively, an excess of gasoline returns to
the fuel tank.
4) Recoil starter
Pull the start knob gently until it is hard to pull (compression point).
Then, return the start knob, and pull it strongly.
Never pull the rope to the full. Once the start knob is pulled, never
release your hand immediately. Hold the start knob until it returns to its
original point.
5) Choke lever
When the engine starts, open the choke lever.
Open the choke lever progressively while checking the engine
operation. Be sure to open the choke lever to the full in the end.
In cold or when the engine is cooled down, never open the choke lever
suddenly. Otherwise, the engine may stop.
6) Warm-up operation
Continue warm-up operation for 2 to 3 minutes.
Note: –If the starter handle is pulled repeatedly when the choke lever remains at “START” position, the engine will not start easily due to
excessive fuel intake.
–In case of excessive fuel intake, remove the spark plug and pull the starter handle slowly to remove excess fuel. Also, dry the
electrode section of the spark plug.
Caution during operation:
If the throttle lever is opened fully in a no-load operation, the engine rotation is increased to 10,000/min or more. Never operate the engine at
a higher speed than required and at an approximate speed of 6,000 - 8,500/min.
OPEN
CLOSE
Carburetor
Primer Pump