Dolmar HT-365 Trimmer User Manual


 
4
FUNCTIONAL DESCRIPTION
CAUTION:
Always be sure that the tool is switched off and
unplugged before adjusting or checking function on
the tool.
Switch action
1
2
3
009279
For your safety, this tool is equipped with a triple
switching system. To turn on the tool, press two out of
three triggers A, B and C. Release either one of the two
pressed triggers to turn off. The sequence of switching is
unimportant as the tool only starts when both switches
are activated.
Straight cut
009280
To trim the hedge straight, pull triggers A and B.
Vertical cut
009281
Cut upwards with both hands pull the switch triggers B
and C and move it in front of your body.
Far area cut
009282
To trim the hedge in far area with both hands pull the
switch triggers A and C.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
unplugged before carrying out any work on the
tool.
Engage the extension cord
CAUTION:
Make sure that the extension cord is unplugged to
the mains outlet.
1
2
3
007542
When engaging the extension cord, secure it to the tool's
cord with the hook complete. Attach the hook about 100
- 200 mm from the extension cord connector. This will
help prevent unintentional disconnection.
Waist cord hook
CAUTION:
Do not attach the holder of waist cord hook to other
than the extension cord. Do not attach it in a
position closer to the tool beyond the hook
complete. Failure to do so may cause an accident
or personal injury.
When using the waist cord hook, use the extension
cord as a standard equipment. Using an extension
cord available in the market may cause an
accident or injury.
1. Hook complete
2. Tool's cord
3. Extension cord
1. Switch trigger B
2. Switch trigger A
3. Switch trigger C