Filter
Top Products
6
13
12
11
- Power Supply
Connect chain saw to correct voltage, that is, be sure
that the voltage supplied is the same as that specified
on the nameplate of the tool (11).
- Replacement Parts
When servicing, use only identical replacement parts (11).
- Polarized Plugs
To reduce the risk of electric shock, this equipment has
a polarized plug (one blade is wider than the other). This
plug will fit in a polarized outlet only one way. If the plug
does not fit fully in the outlet, reverse the plug. If it still
does not fit, contact a qualified electrician to install the
proper outlet. Do not change the plug in any way.
- Wear ear protectors during operation.
- Before making a felling cut, remove dirt, stones,
loose bark, nails, staples and wire from the tree.
- Secure the log so that it will not rol or move suddenly
during operation.
- AVOlD UNINTENTIONAL STARTING. Don’t carry
plugged-in tool with finger on switch. Be sure switch
is OFF when plugging in.
- Attention! Do not expose this tool to rain (12) and
pull plug immediately if the supply cable is damaged
or cut (13).
- The chain saw must not be left outdoors during rain
and it must not be used when wet.
VOLTAGE WARNING:
Before connecting the tool to a power source
(receptacle outlet, etc.) be sure the voltage supplied is
the same as that specified on the nameplate of the tool.
A power source with voltage greater than that specified
for the tool can result in SERIOUS INJURY to the user -
as well as damage to the tool. If in doubt, DO NOT
PLUG IN THE TOOL. Using a power source with voltage
less than the nameplate rating is harmful to the motor.
Use of Extension Cord
If the extension cord is intended to be used outdoors, the
cord shall be marked with the suffix W-A following the cord
type designation, for example - SJTW-A, to indicate it is
acceptable for outdoor use. Use an extension cord heavy
enough to carry the current the tool will draw. Undersize
cord will cause a drop in line voltage resulting in loss of
power and over-heating. Make sure the extension cord is in
good condition before using. Keep the cord away from the
cutting area and to position cord so that it will not be caught
on branches, and the like, during cutting. Use the table below
to determine the proper wire size required in the extension
cord.
Contact DOLMAR Authorized or Factory Service Center if
a proper extension cord cannot be found.
SAVE THESE INSTRUCTIONS !
Indicate when ordering spare parts!
Nameplate ES-171
Ampere rating 0-5.0 5.1-10.0 10.1-13.0 13.1-15.0
(on nameplate)
Ext. Cord Length Wire Size (American Wire Gauge)
25 Ft. 18 18 16 14
50 Ft. 18 16 16 14
75 Ft. 18 16 14 14
100 Ft. 16 14 12 12
125 Ft. 16 12 12 12
150 Ft. 16 12 12 -
2600FPM(800m/min)
Hamburg
Germany
50-60Hz
ES-171DOLMAR
120V~
13 A
No.
16" (400mm) Chain Saw
412.040.661
980.114.472
1500 W
Class 2C. CSA Z 62.1, Z 62.3
528.091.056
®
®
LISTED
82Z2
C