Dixon ZTR 5423 Lawn Mower User Manual


 
OPERATION INSTRUCTIONS
MOWING WITH A GRASS CATCHER ATTACHMENT:
In order to achieve optimum performance when mowing with a grass catching attachment, please read
and follow the tips listed below.
1. Set engine speed control to the wide open or full setting.
2. Do Not Attempt To Cut Grass When It Is Wet. Wet grass will clog both the underside of the deck
and the attachment chutes. Empty bags often to prevent plugging.
3. If the grass is tall, place the mower deck cut height selector in the top or second notch. "Initially"
overlap cutting swaths instead of a full swath with each pass.
4. Keep The Underside Of The Mower Deck Clean. Frequent removal of dried grass and dirt will
greatly assist in bagging of the clippings.
5. Use only the correct blade(s). Some grass catching attachments require a "high-lift" blade. See
your dealer for advice on the type of blade(s) needed for your mower.
6. Maintain Sharp Blade(s) Throughout The Cutting Season.
7. Operate the mower at a slower ground speed than when mowing without a grass catching
attachment.
Watch for low hanging branches or other obstacles which might hit the catcher top while turning
or backing the mower.
Use care when backing to avoid pushing the grass bags into the frame or "hot" exhaust muffler
of the engine.
Disengage blade and stop engine prior to clearing grass from either the discharge chute or grass
catcher components.
Keep all attachment bolts tight.
Do Not operate the mower with the grass catching attachment partially removed.
Important:
Do not leave clippings in the bags while the mower is stored.
Damp grass clippings are a fire hazard if left in the bags.
Page 21