Filter
Top Products
50
CARE AND MAINTENANCE
NEUTRAL ADJUSTMENT:
1. Engage parking brake and raise rear of frame with
jack or blocks so that rear tires do not contact the
ground.
2. Swing out the control levers, start the engine, and
release the paking brake.
3. Raise the upper body to access hydro control linkage.
If right wheel creeps, adjust right side linkage and
vice-versa. Use procedure below.
a. loosen, but do not remove, the bolt in
the control tube (5540)
b. loosen jam nuts on ends of the control
rod (9067)
c. turn control rod in or out until neutral
is achieved
d. tighten jam nuts on control rod
e. tighten bolt in control tube