Page 14
CONTROLS
PARKING BRAKE:
The parking brake is designed to hold the mower from moving
and is not intended for use in stopping the mower while it is
in motion.
TRANSMISSION DRIVE SYSTEM:
Allows the mower to turn on its own axis
"Zero Turning Radius"
Each lever controls one side of the mower.
NOTE: The pressure required to operate the mower is very
light.
TO SET PARKING BRAKE:
The hand operated parking brake is located on the right
fender.
To engage brake, pull lever up(to the rear).
To release brake, move lever forward (down).
NOTE: Always set parking brake before dismounting.
Release parking brake before moving mower.
CAUTION
Engage parking brake before
starting engine.
The Dixon ZTR has a unique transaxle that requires only two drive levers to control
braking, turning, speed, and direction.
On initial operation, set throttle speed on slow. Operate with mower blade "OFF".
To avoid "over-controlling" the mower, use a light touch on the drive levers.
Slight movements using fingertip control is all that is necessary.