Dixon ZTR 4424 Lawn Mower User Manual


 
OPERATION INSTRUCTIONS
SIDE DISCHARGE OF THE CLIPPINGS:
In order to achieve optimum performance when side discharging the grass clippings, please read
and follow the tips listed below.
Additional information can be found in the troubleshooting guide.
CAUTION
Be sure that deflector is properly installed on the
discharge chute.
1. Set engine speed control to the wide open or full setting.
2. Do Not Attempt To Cut Grass When It Is Wet. Wet grass will clog the underside of
the
deck and discharge area.
3. If the grass is tall, place the mower deck cut height lever in the top or second notch. Initially
overlap cutting swaths instead of a full swath with each pass. Some applications may
require a second cutting.
4. Keep The Underside Of The Mower Deck Clean. Frequent removal of dried grass
and dirt
will allow the clippings to discharge correctly.
5. Maintain Sharp Blades Throughout The Cutting Season.
GRASS HEIGHT SUGGESTIONS:
Correct mowing height can reduce weeds and disease by 5O to 8O %
The following grass cut heights are based on adequate moisture conditions and normal thatch
buildup in a healthy lawn. Some locations and applications may require slightly
different cut
heights. If in doubt, consult your local lawn professional for assistance.
Grass Types: Best Cut Heights
Zoysia 2" - 2 1/2"
Blue Grass 1 1/2"- 3"
Fescue Blends 1 1/2"- 3"
St. Augustine [Mid South] 11/2"- 2"
St. Augustine [Deep South] 3" - 4"
Tifton Bermuda 1 1/2"
Centipede 1 1/2"- 2"
Common Bermuda 1 1/2"- 2"
Bahia/Argentina/Pensacola 2"
;
Page 21