Filter
Top Products
SPECIFICATIONS
Model ZTR 3014
CHASSIS:
The monocoque design chassis of the 3000 Series Models incorporates CMC
Laser and CMC brake processes to form the twin 1 2 gauge side frames and 7
gauge transmission and engine base plate.
BODY:
All body parts are made of rotational molded polyethylene. Front body contains
access panel for battery service. Seat tilts forward to allow transmission service.
MOWER DECKS:
36" Deck: 1 1 GA Laser Cut Fabricated - 36" Cut Width 42"
Deck: 1 3 GA Stamped Steel Construction - 42" Cut Width
Cut height approximately 1" to 4" via 7 position lift handle.
BLADE DRIVE: Electric clutch.
TRANSMISSION:
Each rear wheel is independently driven by chain and sprockets through a
friction mechanical drive.
ENGINE:
14 HP Briggs & Stratton OHV I/C Quiet, 4-Cycle, Single Cylinder, Air-Cooled,
Gasoline, Vertical Shaft, Cast Iron Cylinder, Synchro-Balanced, Laminated
Shroud.
STARTING SYSTEM:
Electric by key switch operation with safety interlocks on parking brake and blade
drive.
TIRES:
Front 11 X 4.00 -5 ribbed tread. Rear
1 8 X 8.50 X 8 Multi Trac tread.
CAPACITIES:
Fuel 2.0 gallons total.
Engine 1 .25 quarts oil.
DIMENSIONS:
Width 43.0" outside rear wheel measurement. Height
36.0" to top edge of seat. Length 65.5" hitch tab to front
bumper. Weight 36" Deck: 500 Ibs. 42" Deck:
520 Ibs.
NOTE: Additional information provided in service instructions under the individual component.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE.
Page
10