Filter
Top Products
SPECIFICATIONS
Model ZTR 3303
CHASSIS:
The monocoque design chassis of the 3000 Series Models incorporates CMC
Laser and CNC brake processes to form the twin 12 gauge side frames and 7
gauge transmission and engine base plate.
BODY:
All body parts are made of rotational molded polyethylene. Front body contains
access panel for battery service. Seat tilts forward to allow transmission service.
MOWER DECK:
1 1 GA stamped steel construction. Single 30" cut blade.
Cut height approximately 1 " to 4" via 7 position lift handle.
BLADE DRIVE: Mechanical; hand lever engagement.
TRANSMISSION:
Each rear wheel is independently driven by chain and sprockets through a
friction mechanical drive.
ENGINE:
10.5 HP I/C Briggs & Stratton, 4-Cycle, Single Cylinder, Air-Cooled, Gasoline,
Vertical Shaft, Aluminum Head and Block.
STARTING SYSTEM:
Electric by key switch operation with safety interlocks on parking brake and blade
drive.
TIRES:
Front 11 X 4.00-5 ribbed tread. Rear
1 6 X 6.50 X 8 Turf Trac R/S Tread.
CAPACITIES:
Fuel 2.0 gallons total.
Engine 1 .25 quarts oil.
DIMENSIONS:
Width 32.5" outside rear wheel measurement.
Height 32.0" to top edge of seat. Length
65.5" hitch tab to front bumper. Weight 430 Ibs.
NOTE: Additional information provided in service instructions under the individual component.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE.
Page 8