Filter
Top Products
English-33
OPERATION
Moving by Hand
When pushing or pulling the mower, be sure to engage
the IZT (Integrated Zeroturn Transaxle) bypass
linkages.
• Always turn off engine before engaging or
disengaging the hydro release. Never
attempt to adjust the bypass linkages with the
engine running.
• The hydro release valves are located below
the seat, on the front side of the hydro
pumps.
• Raise the deck into the highest cutting
position.
• Lift the seat frame assembly to access the
release valves.
• Use a
5
/8" wrench to rotate bolt counter-
clockwise two full turns to disengage pump.
• Repeat the procedure for the opposite pump.
• To engage, rotate each pump bolt clockwise
until the bolt is snug. Do not overtighten the
release valve or damage to the hydro pump
could occur.
WARNING!
Make no adjustments without:
♦♦
♦♦
♦ the engine stopped
♦♦
♦♦
♦
the ignition key removed
♦♦
♦♦
♦ the parking brake activated
1. Left hydro gear
2. Release valve
Bypass linkages
8050-767
1
2