Dixon ZTR34/968999731 Lawn Mower User Manual


 
English-12
SAFETY
Maintenance
Safe Handling of Gasoline
To avoid personal injury or property damage, use
extreme care in handling gasoline. Gasoline is
extremely flammable and the vapors are explosive.
Extinguish all cigarettes, cigars, pipes, and
other sources of ignition.
Use only approved gasoline container.
Never remove gas cap or add fuel with the
engine running. Allow engine to cool at least
two (2) minutes before refueling.
Never fuel the machine indoors.
Never store the machine or fuel container
where there is an open flame, spark, or pilot
light such as on a water heater or other
appliances.
Before you begin refueling, minimize the risk
of static electricity by touching a metal
surface.
Never fill containers inside a vehicle or on a
truck or trailer bed with plastic liner. Always
place containers on the ground away from
your vehicle when filling.
Remove gas-powered equipment from the
truck or trailer and refuel it on the ground. If
this is not possible, then refuel such
equipment with a portable container, rather
than from a gasoline dispenser nozzle.
Keep the nozzle in contact with the rim of the
fuel tank or container opening at all times until
fueling is complete. Do not use a nozzle lock-
open device.
If fuel is spilled on clothing, change clothing
immediately.
Never overfill fuel tank. Replace gas cap and
tighten securely.
Do not start the engine near spilled fuel.
Never use gasoline as a cleaning agent.
If leaks arise in fuel system, engine must not
be started until problem has been resolved.
Check the fuel level before each use and
leave space for the fuel to expand, because
the heat from the engine and the sun may
otherwise cause the fuel to expand and
overflow.
WARNING!
The engine must not be started when the driver’s floor plate or any protective
plate for the mower deck’s drive belt is removed.
Never fill the fuel tank indoors
8011-516
WARNING!
The engine and the exhaust
system, become very hot
during operation.
Risk for burns if touched.
Allow engine and exhaust
system to cool at least two (2)
minutes before refueling.