Filter
Top Products
SEAT ASSEMBLY INSTRUCTIONS
1.
Assemble one arm rest bracket to arm rest cushion using (2) 5/1 6 standard flat washers (3020)
and (2) 5/16-18 x 1 hex head nylok bolts (3224). Do not tighten hardware at this time.
2.
Assemble arm rest bracket/cushion to seat bottom using (3) 5/16 sta
ndard flat washers (3020)
and (3) 5/16-18 x 1 hex head nylok bolts (3224). Do not tighten hardware at this time.
3.
Repeat steps 1 and 2 for other arm rest bracket.
4.
Assemble arm rest brackets and utility box to seat back using (4) 5/1 6 standard flat
washers
(3020) and (4) 5/1 6-18x1 hex head nylok bolts (3224). Tighten all seat hardware at this time.
5.
Place seat assembly on body, and connect seat safety switch.
6.
Place (1) seat spacer (1849) on each stud protruding through seat bottom, and insert
studs
through slots in body. Firmly hold seat assembly against body with one hand while body is raised
to fully open position. Continue to hold seat against body to prevent damage to seat safety
switch wiring.
7.
Install (1) 5/16 standard flat washer (30
20), (1) seat knob (3874), and (1) nylok nut (3205) on
each of the front studs extending through body and seat frame, and tighten these nuts.
8.
Install (1) 5/16 standard flat washer (3020) and (1) nylok nut (3205) on each of the rear studs.
Do not fully
tighten these nuts, thus allowing for easy slide action of seat, as provided by knobs
on front studs.
Page 7