Filter
Top Products
CARE AND MAINTENANCE
Deck Removal - Zeeter HL 30”
1. Place cut height lever in lowest cut position.
2. Loosen belt keepers.
3. Remove deck drive belt from engine pulley.
4. Using a slight upward twisting motion, remove link from
engagement handle.
5. Turn handle fully to the left until handle clears stop on mower
deck pan. Lift handle then remove handle down through hole
in lower fender.
6. Remove hair pin cotter and washer from one end of deck
support cross shaft. Note location of remaining shim wash-
ers used between chassis and mower deck pan arms. Slide
shaft from
chassis and mower deck.
7. Remove hair pin cotter and washer from each deck adjust-
ment rod. Carefully push each link to disengage from deck lift
arms. At this point, deck will drop down.
8. Carefully raise and support front of chassis. Slide
mower deck to either side for removal. (Reverse
procedure to reinstall deck assembly.)
36