Filter
Top Products
CONTROLS
19
—Fig. 2—
PARK BRAKE:
The park brake is designed to hold the
mower from moving and is not intended for
use in stopping the mower while it is in
motion. The engine will stop if the park brake
is engaged while the control levers are in the
drive position.
TO SET PARK BRAKE:
The hand operated park brake is located on
the operator’s right.
•To engage brake, pull lever up (to the rear).
•To release brake, move lever forward (down).
NOTE: Always set park brake before dismounting.
Release park brake before moving mower.
TRANSMISSION DRIVE SYSTEM
Allows the mower to turn on its own axis
“ZERO TURNING RADIUS”. Each lever controls
one side of the mower.
NOTE: The pressure required to operate the mower is very light.
CAUTION
!
Engage park brake before
starting engine.