Dixon 965882001 Lawn Mower User Manual


 
DIXON-49
MAINTENANCE
Anti-scalp rollers
Anti-scalp rollers are properly adjusted when they
are just slightly off of the ground when the deck is at
the desired cutting height in the operating position.
Anti-scalp rollers then keep the deck in the proper
position to help prevent scalping in most terrain
conditions.
IMPORTANT INFORMATION
Adjust anti-scalp rollers with the mower on a
at level surface.
The anti-scalp rollers can be set in three positions:
Upper position 1½ to 2½" (38 to 64 mm) grass
Middle position 2½" to 4" (64 to 102 mm) grass
Lower position 4" to 6" (102 to 128 mm) grass.
The rollers should be approximately ¼" (6.5 mm) from
ground. Do not adjust the rollers to support the deck.
IMPORTANT INFORMATION
The anti-scalp rollers must not be used for
gauge wheels or the roller and deck may be
damaged.
8050-830
Anti-scalp rollers
IMPORTANT INFORMATION
DO NOT add any type of tire liner or foam ll
material to the tires. Excessive loads created
by foam lled tires will cause premature
failures.
Only use O.E.M. specied tires.
8011-619-4
1. Caster yoke
2. Caster bolt
3. Caster long spacer
4. Caster small spacers
Caster wheels
2
1
3
Caster Wheels
Check every 200 hours. Check that wheels rotates
freely. If wheels do not rotate freely take the unit to
your dealer for service.
Foam lled tires or solid tires will void the warranty.
Removal and installation of caster wheel
Remove nut and caster bolt.
Pull the wheel out of the yoke and take care of the
spacers.
Install in reverse order. Tighten caster bolt.
Hardware
Check daily. Inspect the entire machine for loose or
missing hardware.
4