Filter
Top Products
9
ASSEMBLY
3
BAGGER SUPPORT ASSEMBLY
4
MOUNTING COVER ASSEMBLY TO
SUPPORT ASSEMBLY
NOTE: For ease of assembly, you may wish assis-
tance from another person for mounting the cover
assembly to mower.
1. Position cover assembly on ground behind mower.
2. Lift and rotate cover to align the cover bracket with
hanger bracket and slide the cover down until
secure.
Frame Bracket
Hanger
Bracket
1. Attach bagger support to engine guard using four
3
/8 -16 x ¾ bolts and four
3
/8 -16 nyloc nuts.
2. Using bagger support as a template, drill two
11
/32
holes through the engine guard toward the
bottom. (See illustration)
3. Attach hanger bracket to bagger support with four
5
/16 -18 x 1 carriage bolts and four
5
/16 nyloc nuts.
(See illustration)
4. Remove top side bolts on the engine guard.
Attach support straps and engine guard to frame
using two
5
/16 -18 x 1 carriage bolts and two
5
/16 -18 nyloc nuts.(See illustration) Make sure
support strap tabs are facing toward the rear.
Attach tab end of support straps to bagger
support using two
5
/16-18 x 1 bolts and two
5
/16 -18
nyloc nuts.
5
CONTAINER MOUNTING
1. Install container, centering between support
tubes.
NOTE: One container should always overlap
the other container at supports.
2. Close cover and lock latch handles over center
support tubes.
Cover Latch
Handle
Support
Tubes
Container
Bags
Support Strap Tab
Hanger Bracket
Drill Two
11
/32 holes into
engine guard to match
these holes
Engine Guard
Bagger Support
Support Strap
WARNING
DO NOT operate mower unless container is
properly installed. Container is subject to wear
and deterioration, check containers frequently,
replace when cracked or damaged. Use only a
recommended replacement container.