Filter
Top Products
30
CARE AND MAINTENANCE
CUTTER BLADE MAINTENANCE:
CAUTION Stop engine and remove ignition key for
safety. Wear heavy, thick gloves when
holding onto cutter blade, avoid the sharp
edge of the blade.
Blades should be discarded when worn excessively.
Check sharpness of mower blades after every 10 hours
of operation. Observe proper blade position prior to
removal.
1. Safely raise front of mower.
2. Hold or block blade from
turning.
3. Loosen blade bolt and remove
blade.
4. When replacing blade, tighten
blade bolt securely. Refer to
diagram. Be sure blade is
centered on pilot before
tightening bolt to 60 ft. lbs.
DANGEROUS!
DO NOT USE
BLADE IN THIS
CONDITION!
When notch starts,
discard blade
New Blade